MSDS
NAPHTHALAT - W
Identity Information
NAME: Sodium Naphthalat  (SODIUM SALTS OF FORMALDEHYDE HIGH-CONDENSATE NAPHTHALENE SULFATE SUPERPLASTICIZER)
 
INGREDIENTS
  NAME CAS# CONCENTRATION
  Sodium salt of Poly naphthalene 36290-04-7 > 92%
  Sulfonic acid  
 
PHYSICAL DATA
  CONTENT %: > 92 PH: 7.0-9.0 Na2SO4 % <  5.0
  Vapour pressure N.A.
  %Volatile(by weight): 6-9% Boiling point N.A.
  Evaporation rate N.A.
  Freezing point N.A.
  Odour threshold N.A.
  Partition coef.(n-octano/water) N.A.
 
FIRE AND EXPLOSION HAZARD DATA
  Extinguishing media: Incombustible Explosion data N.A.
  Lower flammalble limit N.A.
  Flash point N.A.
  Auto-ignition temp N.A.
  Higher flammable limit N.A.
  NFPA fire code 0
  Hazardous combustion products N.A.
 
STABILITY AND REACTIVITY
  Chemical stability: stable Incompatibility N.A.
  Conditions reactivity Extremely high temperature(thermal decomposition)
  Hazardous polymerization N.A.
  Hazardous decomposition At very high temperatures, carbon oxide and sulfur oxides
 
FIRST AID MEASURES
  Inhalation Incase of discomfort, move to a ventilated area
  Skin contact Flush skin thoroughly with water
  Eye contact Flush eyes with water and carefully rinse under eyelids
  If irritation persists, consult physician If victim is conscious, induce vomiting. Give a large quantity of water.
  Get medical attention.  
 
HAZARDS IDENTIFICATION
  Potential Health Effects  
  Eye May cause eye irritation
  Skin May cause skin irritation
  Ingestion Low hazard for usual industrial handling
  Inhalation May cause respiratory tract irritation
 
TOXICOLOGICAL PROPERTIES
  ROUTES OF ENTRY N.A
  inhalation N.A
  skin absorption × eye contact × ingestion × skin contact
  ACUTE TOXICITY Inhalation May cause irritation to nose, throat and mucous membranes of respiratory traces
  Skin contact Not irritant
  Eye contact Slightly irritant
  Ingestion The product is moderately toxic if ingested. LD50 (orat-rat):>180mg/kg
  CHRONIC TOXICITY Prolonged or repeated skin contact can cause irritation
  EXPOSURE LIMITS ACCIH(TLV) DSHA(PEL)
  TWA STEL TWA STEL  
  Sodium salt of poly-naphthalene N.D. N.D. N.D. N.D.
  sulfonic acid  
  Carcinogenicity/Mutagenicity/Teratogenicity Dose not contain any carcigens or potential carcinogens (IARC, NTP, OSHA)
 
PREVENTIVE MEASURES
PERSONAL PROTECTION: Wear a dust respirator. Where splashes of the product (liquid, solution) may occur, wear goggles and/or face shield and impervious gloves.
HANDLING METHODS: Handle the solution product in containers, piping and pumps made of stainless steel, fiberglass or plastic. Galvinzed steel may be used for piping. Avoid prolonged or repeated skin contact.
 
STORAGE
Avoid freezing. Avoid contact with the eyes, skin and clothing. Wash thoroughly after handling. Keep out of reach of children.
 
SPECIAL PROTECTION INFORMATION
Adequate fresh air
 
ECOLOGICAL INFORMATION
No special
 
ACCIDENTAL RELEASE MEASURES
Spills/Leaks: Vacuum or sweep up material and place into a suitable disposal container. Avoid generating dusty conditions.
 
TRANSPORT INFORMATION
Contact BES Chemical company for transportation information.
 
 
REGULATORY INFORMATION
TRANSPORT INFORMATION: IDENTIFICATION NUMBER N.A.
CLASSIFICATION N.A. USA REGULATIONS: No ingredient of this product if subject to the reporting requirements of section 313 of Title III of the “Superfund Amendment and Reauthorization Act II (SARA)of 1986 and 40CFR part 372 of United States.
 
OTHER INFORMATION

The information and recommendations set forth herein are based on data we have in our possession and we have reason to believe is accurate. It is, however, the user's responsibility to determine the safety, toxicity, and suitability for his own use of the herein described product. Because the actual by others is beyond our control, BES Kimya Ltd., makes no warranty expressed or implied regarding accuracy of the results to be obtained from the use thereof.